Vape Juice production: mistakes
Vape Juice is a specification decision before it is a price decision. Get the resistance, the capacity and the packaging right and the price conversation becomes short. Get them wrong and no discount will rescue the order.
Published 28 May 2025 · VapeWholesaleHub · Reading time 5 min
Price breaks and payment terms
We work with B2B buyers who order between a few hundred and a few thousand units at a time, and we treat both ends the same way: a written specification, a sample you approve, and a production run that matches the sample.
Payment terms for new accounts are normally a deposit with the balance against the bill of lading. Established buyers on a repeat schedule can move to terms after three clean shipments.
The cheapest way to lower your cost per unit is usually to remove a SKU, not to negotiate a discount. Fewer lines means larger runs, fewer changeovers and a better price at the same quality.
Labels, closures and traceability
Age verification is not only a website problem. Retail packaging, shelf placement and staff scripting all carry compliance weight, and auditors increasingly ask for evidence of all three.
If you sell into a market that requires child-resistant packaging, say so at quotation stage. Retrofitting a CR closure onto a finished bottle design usually means a new mould and a four week delay.
Getting the carton there intact
We ship from Shenzhen and Guangzhou: air express for samples and part loads, sea freight for volume. Typical production lead time is 20 working days after artwork approval, plus transit. We quote both routes so you can see the trade-off instead of guessing at it.
Damage in transit is nearly always a packing decision, not bad luck. Double-walled cartons, internal dividers and a drop-tested configuration cost a little more and save the argument at the other end.
- Specification locked in writing before production starts
- Private label files archived for future rebrands
- Mixed SKU cartons to spread first-order risk
- Consolidated or split shipping, quoted both ways
- Artwork proof plus physical dummy for custom packaging
- Batch codes traceable from carton back to production date
Batch consistency and why it matters
Battery safety is not a marketing line. Cells are matched by capacity and internal resistance before assembly, charging boards are checked for cut-off voltage, and any unit that fails the cut-off test never reaches packing.
Flavour drift between batches is the quiet killer of repeat orders. We retain a sealed reference sample from every run so a complaint six weeks later can be compared against what actually left the building.
Specification summary
| Volume | 100 ml |
| Strength | 6 mg |
| Base ratio | 50/50 PG-VG |
| Flavour range | 24 profiles |
| Closure | Child resistant |
| Bottle | PET |
| Minimum order | 100 units per SKU, mixed cartons allowed |
| Lead time | 30 working days after artwork approval |
None of this is complicated. It is just written down, which is more than most buyers get before they wire a deposit.
Frequently asked
Can we order samples before committing?
Yes. Sample orders are shipped by air express and the cost is credited against your first production order above 60 units. We would rather you handle the sample than approve a specification from a photograph.
What happens if part of the order is defective?
Report within seven days with photos and the batch code. Confirmed defects are replaced or credited on the next shipment. The failure is logged by mode and batch, and reviewed monthly with the factory.
How long does production take?
Around 20 working days after artwork approval for stock configurations, plus transit. Custom runs add roughly a week for tooling and a physical dummy. We confirm the date in writing on the order acknowledgement.
Related reading
Need a quotation on vape juices?
Send destination market, target price and quantity. Same-day reply on working days.
Tel / WeChat / WhatsApp +86 13711127975 · vape@0099933.xyz