Vape Juice packaging and carton specs for B2B buyers
Buyers come to us for vape juice after a bad quarter: dead stock on one side, empty shelves on the other. The cause is usually the same, an assortment built from a catalogue instead of from sell-through data. This page explains how we rebuild that balance for B2B buyers.
Published 16 December 2025 · VapeWholesaleHub · Reading time 9 min
Merchandising a small range well
We ship vape juices to distributors, chain buyers and independent shops. What follows is the material we normally cover in a first conversation: what we hold in stock, how we test it, how it ships, and what happens when a carton arrives damaged.
Seasonality in vape juices is real but smaller than most buyers assume. The bigger swing comes from restocking discipline, not from calendar events.
Shelf position decides velocity as much as price. Keep vape juices at eye level, one facing per SKU, and rotate the trial line every quarter so the display keeps earning attention.
Compliance without the last-minute scramble
Artwork approval is a two stage process: a digital proof for text and layout, then a physical dummy for colour and finish. Skipping the dummy is the single most common cause of a reprint.
If you sell into a market that requires child-resistant packaging, say so at quotation stage. Retrofitting a CR closure onto a finished bottle design usually means a new mould and a four week delay.
The checks behind every shipment
Leak complaints almost always trace back to one of three things: an over-torqued centre post, a seal that sat in a hot container, or a fill volume pushed past the design limit. We cap fill volume slightly below maximum for exactly that reason.
We photograph the packing station during production for volume orders. It is a small thing, but it settles most arguments about what was actually in the carton before it was sealed.
- Consolidated or split shipping, quoted both ways
- Document pack prepared per destination market
- Specification locked in writing before production starts
- Seven-day defect reporting with replace-or-credit
- Named account contact who has handled the product
- Private label files archived for future rebrands
Building an assortment that actually turns
We keep a short list of approved configurations for vape juices. Anything outside that list is possible, but it becomes a custom run with a custom lead time, and we quote it as such rather than pretending everything is standard.
The first question we ask is not what you want to spend. It is what your customer already buys. Answer that and the vape juice list writes itself; skip it and you end up with a pallet of stock that photographs well and sells badly.
Specification summary
| Volume | 50 ml |
| Strength | 3 mg |
| Base ratio | 70/30 VG-PG |
| Flavour range | 48 profiles |
| Closure | Child resistant |
| Bottle | PET |
| Minimum order | 100 units per SKU, mixed cartons allowed |
| Lead time | 12 working days after artwork approval |
None of this is complicated. It is just written down, which is more than most buyers get before they wire a deposit.
Frequently asked
Can we order samples before committing?
Yes. Sample orders are shipped by air express and the cost is credited against your first production order above 500 units. We would rather you handle the sample than approve a specification from a photograph.
What is the minimum order for vape juice?
Standard configurations start at 500 units per SKU, with mixed SKUs allowed inside the same carton. Custom colours, custom packaging or a private label run usually start at 1000 units because of setup time on the line.
What documents come with a shipment?
Commercial invoice, packing list, and the certificate pack for your market: test reports, declaration of conformity and safety data sheets. We send scans before dispatch so your broker can pre-clear the file.
Related reading
Need a quotation on vape juices?
Send destination market, target price and quantity. Same-day reply on working days.
Tel / WeChat / WhatsApp +86 13711127975 · vape@0099933.xyz