Vape Juice MOQ and minimum order quantity — a overview
Vape Juice sits in a crowded price band, and the cheapest quote on the sheet is rarely the cheapest unit on your shelf. Everything below is built around reorder rate, defect rate and cash conversion rather than headline unit price.
Published 22 September 2026 · VapeWholesaleHub · Reading time 9 min
Labels, closures and traceability
Vape Juice is a specification decision before it is a price decision. Get the resistance, the capacity and the packaging right and the price conversation becomes short. Get them wrong and no discount will rescue the order.
Regulation for vape juices differs by country and sometimes by state. We do not pretend to be your lawyer, but we do keep the document pack current and we will tell you when a configuration cannot legally enter a market you have named.
If you sell into a market that requires child-resistant packaging, say so at quotation stage. Retrofitting a CR closure onto a finished bottle design usually means a new mould and a four week delay.
What we test before a carton is sealed
Leak complaints almost always trace back to one of three things: an over-torqued centre post, a seal that sat in a hot container, or a fill volume pushed past the design limit. We cap fill volume slightly below maximum for exactly that reason.
Flavour drift between batches is the quiet killer of repeat orders. We retain a sealed reference sample from every run so a complaint six weeks later can be compared against what actually left the building.
Transit, consolidation and timing
Damage in transit is nearly always a packing decision, not bad luck. Double-walled cartons, internal dividers and a drop-tested configuration cost a little more and save the argument at the other end.
Transit times move with the season. Book space early for Q4 and around Chinese New Year, when factory output pauses for two to three weeks and freight rates tighten at the same time.
- Document pack prepared per destination market
- Reference sample retained from every batch
- Batch codes traceable from carton back to production date
- Mixed SKU cartons to spread first-order risk
- Consolidated or split shipping, quoted both ways
- Seven-day defect reporting with replace-or-credit
Presentation that earns the step-up
Seasonality in vape juices is real but smaller than most buyers assume. The bigger swing comes from restocking discipline, not from calendar events.
Shelf position decides velocity as much as price. Keep vape juices at eye level, one facing per SKU, and rotate the trial line every quarter so the display keeps earning attention.
Specification summary
| Volume | 50 ml |
| Strength | 6 mg |
| Base ratio | 70/30 VG-PG |
| Flavour range | 24 profiles |
| Closure | Child resistant |
| Bottle | PET |
| Minimum order | 100 units per SKU, mixed cartons allowed |
| Lead time | 18 working days after artwork approval |
None of this is complicated. It is just written down, which is more than most buyers get before they wire a deposit.
Frequently asked
Can we order samples before committing?
Yes. Sample orders are shipped by air express and the cost is credited against your first production order above 60 units. We would rather you handle the sample than approve a specification from a photograph.
What happens if part of the order is defective?
Report within seven days with photos and the batch code. Confirmed defects are replaced or credited on the next shipment. The failure is logged by mode and batch, and reviewed monthly with the factory.
How long does production take?
Around 12 working days after artwork approval for stock configurations, plus transit. Custom runs add roughly a week for tooling and a physical dummy. We confirm the date in writing on the order acknowledgement.
Related reading
Need a quotation on vape juices?
Send destination market, target price and quantity. Same-day reply on working days.
Tel / WeChat / WhatsApp +86 13711127975 · vape@0099933.xyz